Razor RSF650 3.00-10 Inner Tube
Replacement 3.00-10 inner tube for the Razor RSF650 electric sport bike where the original 10-inch pneumatic wheel uses a tube and angled valve.
Specification
- Tube size: 3.00-10
- Wheel/rim size: 10 inch
- Valve: 45° angled / bent Schrader (car-type) valve
- Quantity: 1 inner tube
- Position: Front or rear only where the wheel uses the stated tube size and valve orientation
- Condition: Brand new aftermarket replacement part
Fitment
- Vehicle: Razor RSF650 electric sport bike.
- Tube/tyre application: 3.00-10; this size is also commonly referenced for the RSF650 as 100/80-10.
- Suitable for front or rear only where the wheel uses the same tube-type 3.00-10 setup.
- Check the tyre marking and compare the valve direction with the removed tube before fitting.
Why the angled valve matters
Small 10-inch wheels can leave limited access around the rim. A bent Schrader stem can make pressure checks and inflation easier than a straight stem where the original wheel is designed for an angled valve.
Important size information
3.00-10 refers to a tyre/tube size for a 10-inch rim. It is not the same size as 3.00-4, 10x3.00-4 or other small-wheel markings that may also contain the number 10. Match the tyre sidewall marking and valve position before ordering.
Some aftermarket 10-inch tubes are marketed across several nearby tyre sizes, but this listing only claims 3.00-10 as the confirmed tube size unless a model-specific application below is stated.
Before fitting
- Check the tyre sidewall reads 3.00-10 or the model-specific equivalent stated in this listing.
- Confirm the wheel is intended to use an inner tube. Do not add a tube to a tubeless setup unless the wheel/tyre manufacturer permits it.
- Compare the valve angle and valve exit position with the old tube/rim.
- Inspect the tyre and rim for sharp objects, corrosion, damaged rim tape or other causes of the previous puncture.
- Inflate the new tube slightly before installation so it sits without twists or folds, and avoid pinching it with tyre levers.
- Inflate to the pressure specified by the vehicle/tyre manufacturer; the tube itself does not set the correct operating pressure.
Package contains: 1 x 3.00-10 inner tube. Tyre, wheel/rim and fitting tools are not included.